Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Assembly and Maintenance
3
Beiträge
1
Benutzer
0
Likes
691
Ansichten
Themenstarter
Only recently built my M1000. Using the jogging arrows on UCCNC it stops before activating the limit switches in X and Y axis but not Z. It does stop when reaching the switches but then I have to reset. I have two questions:
How do I train it to know a Z soft limit?
After a reset I go HOME; are my x,y,z zeros still correct after going home?
Veröffentlicht : 01/01/2024 4:54 pm
Themenstarter
I found the problem. In the configuration the Z axis limit was set to 1. Changed it to 0 and all is well.
Veröffentlicht : 02/01/2024 11:27 am
Themenstarter
This board software isn’t very good is it?
I found the problem, my Z axis limit was set to 1, changed it to 0 and all is well.
Veröffentlicht : 02/01/2024 11:31 am
