file Question cant get the A Axis to feed

  • majorcrankie
  • majorcrankie's Avatar Topic Author
  • Offline
  • Forum Nutzer
  • Forum Nutzer
More
10 Jun 2017 00:42 #48023 by majorcrankie
cant get the A Axis to feed was created by majorcrankie
hello all I cant seem to get the a axis to feed . I have did what stepcraft has said and still no luck anybody have any ideas . I think its a setting in uccnc but not sure what to look for

thanks for all and any help

Please Log in or Create an account to join the conversation.

More
15 Jun 2017 22:55 #48137 by Doug
Replied by Doug on topic cant get the A Axis to feed
Check on the Configuration/Axis Setup tab for the A axis whether the axis is enabled or not (checkbox ticked).

Doug

Stepcraft 2/840, StoneyCNC industrial HF spindle, 4th axis, TurboCAD 2016 Professional 64 bit, MeshCAM, GWizard feeds & speeds calculator, UCCNC
Hobby use: guitar building (luthiery), www.facebook.com/DougShortGuitarBlog/

Please Log in or Create an account to join the conversation.

Powered by Kunena Forum

© 2019 STEPCRAFT GmbH & Co. KG