Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Accessories
3
Beiträge
2
Benutzer
0
Likes
5,388
Ansichten
Themenstarter
Is there anyone who has some experience with the Stepcraft Drag Knife?
I like to buy one to cut my own stickers and letters.
Now I understand from the Operating instructions that I first have to zero the Z-axis, when the knife touched the material.
And in my Aspire program zet the Z-axis on a 2 to 5 mm cutting depth?
On the drag knife than you set the cutting depth of the sticker material.
Is that correct? Or do I miss something.
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Veröffentlicht : 17/11/2016 5:29 pm
Hi!
Yes, you adjust the knife depth on the dragknife to go through the vinyl and halfway into the backing paper, maybe 0.1 mm or just test. Then the knife is mounted in an assembly that is spring loaded so you could set the cutting depth to 2-4 mm just so it presses down properly against the material. These 2-4mm won't affect the cutting depth of the knife.
Best regards
Audun
Veröffentlicht : 17/11/2016 5:47 pm
Themenstarter
Thanks,
Now I'am certain.
Oh and for the users of Vectric Aspire or Vcarve that program has a Gadget included for Drag Knife;)
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Veröffentlicht : 17/11/2016 9:20 pm
