Question Tool Length Sensor - TS-32

Hi All,

I was wondering if someone could help me please. I am just setting the Tool Sensor TS-32 and have configured the UNCNC software as per the instructions, www.stepcraft-systems.com/images/SC-Service/Anleitungen-EN/EN-Operating-Instructions-TLS_v1.pdf

In summary;

1) I have connected the sensor to the rear of the machine directly into the jack socket of the interface board
2) I have configured the Tool Length sensor, Probe Pin = 10 and Port = 1
3) I have download and replaced the M31.txt file


However once I have run the instruction as per "Use of the Tool Length Sensor in UCCNC" the software does not seem to store the calculate 0 value for the Z axis and the height is incorrect. I can manullay zero Z Axis.

Any ideas.

Many thanks,

Matt