- Posts: 41
- Thank you received: 5
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Wenn das Spaß machen soll, wirst du mit 1500 € nicht wirklich auskommen. Bei einer Nutzlänge von 50 mm kommst du mit 1/8"-Fräsern nicht mehr hin. Da sprechen wir von 6 bis 8 mm Durchmesser. Ob man eine Maschine mit gepressten Aluführungen (egal ob Steppi oder GoCNC) und Messingrollen ausreichende Stabilität hat, wage ich zu bezweifeln.Bei dem zu bearbeitenden Halbzeug handelt es sich um:
Holzmaterial (Eiche, Nussbaum, MDF etc) bis 50mm
Plexiglas bis 20mm
Aluminium bis 5mm.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
felix_gorgas wrote: Hallo alpenkreuzer,
da kann ich dir dann klar wiedersprechen. Die Seite www.einfach-cnc.de kenne ich nicht und den Autor kenne ich ebenfalls nicht. Nach kurzem Klick in den Shop von www.einfach-cnc.de habe ich das Buch gefunden. Als Beschreibung wird aufgeführt, dass es rein den Zusammenbau einer "Mach3" gesteuerten Maschine Punkt für Punkt durchgeht. Ist die Stepcraft eine Mach3? Keine Ahnung!
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Lad dir mal EstlCam runter. Das kann man vollkommen unbeschränkt testen. Christian hat alle relevanten Details in Hilfetexten in das Programm gepackt.vielen Dank für die Informationen. Der Preis durch die Angabe von speedo gestaltet sich sehr atraktiv. Welchen Arduino müsste ich denn nehmen und gibt es die nötige Steuersoftware (die auf den Arduino kommt) schon fertig?
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
felix_gorgas wrote: Wenn ich den Arduino insetzte, muss ich dann noch etwas "bauen" in Form von Lötarbeiten oder Bastelei? Ich habe an anderer Stelle etwas von einem "Shield" gelesen, konnte aber noch ncihts finden.
Wichtig ist das ein ATMega328 verbaut ist und die USB-Kommunikation über einen AT-Mega16U2 und nicht über einen FTDI oder CH340 läuft (falls dir das was sagt).
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
We use cookies on our website. Some of them are essential for the operation of the site, while others help us to improve this site and the user experience (tracking cookies). You can decide for yourself whether you want to allow cookies or not. Please note that if you reject them, you may not be able to use all the functionalities of the site.