Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Assembly and Maintenance
3
Beiträge
2
Benutzer
0
Likes
4,309
Ansichten
Themenstarter
Hi, I received my 840 today and I'm missing some parts.
I got 3x59, while the manual requires 4. I suppose I'd have to mail stepcraft and ask for it. I'm also going to check every part right now.
The problem I have are the screws M6x10 that fit in part 59. Do I have to shorten them? How? cutting them? Because there is no fit.
check the photos:
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
Veröffentlicht : 10/07/2015 4:42 pm
That looks a long way off. I had a similar problem with mine, I held the screws in soft jaws in a vice and simply filed them to the correct length. You might want to hacksaw a small amount off them file them. Before you cut the screws run a m6 nut down the thread so any flattened threads will be repaired when you take the nut off.
Did you buy your stepcraft direct or from a dealer? Very frustrating with missing part, hope you get it soon!
Hal
SC840, HF500, UCNNC, Vcarve Pro, Turbo Cad
Veröffentlicht : 10/07/2015 8:12 pm
Themenstarter
That looks a long way off. I had a similar problem with mine, I held the screws in soft jaws in a vice and simply filed them to the correct length. You might want to hacksaw a small amount off them file them. Before you cut the screws run a m6 nut down the thread so any flattened threads will be repaired when you take the nut off.
Did you buy your stepcraft direct or from a dealer? Very frustrating with missing part, hope you get it soon!
Hal
Hi, I did the same, filed them for 2 mm and now it fits perfectly.
I bought it from stepcraft-systems, sent them an email.
One thing I found is some of my track rollers in the Z axis won't turn if I apply some force to the screws (like the manual says). That's not suppose to happen I think.
Also, the wires were a pain to insert in the tubes!
I've finished the Z axis I think.
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
Veröffentlicht : 10/07/2015 11:26 pm
