- Posts: 8
- Thank you received: 0
Question
sc840 fault
- Woodsmith
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
21 Apr 2018 12:46 #53538
by Woodsmith
sc840 fault was created by Woodsmith
Machine starts simple engraving task ....after 15seconds machine stops but program still running ...left hand green light is out !
I try again ...two green lights...starts ok then same again .....clicking noise from below machine bed ..
Can anyone help please.
I try again ...two green lights...starts ok then same again .....clicking noise from below machine bed ..
Can anyone help please.
Please Log in or Create an account to join the conversation.
- Gael
-
- Offline
- Forum Nutzer
-
Less
More
- Posts: 14
- Thank you received: 0
25 Apr 2018 08:47 #53584
by Gael
Replied by Gael on topic sc840 fault
Hello,
When you manually jog the axis all along their travel span, is everything alright?
Did you try to engrave at a slower speed to see if it changes something to the problem?
++
Gaël
When you manually jog the axis all along their travel span, is everything alright?
Did you try to engrave at a slower speed to see if it changes something to the problem?
++
Gaël
Please Log in or Create an account to join the conversation.
- Woodsmith
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
- Posts: 8
- Thank you received: 0
25 Apr 2018 11:56 #53586
by Woodsmith
Replied by Woodsmith on topic sc840 fault
Thanks for suggestion....It was probably bad usb connection. Estop and machine all working well .Appears to be intermittent
Please Log in or Create an account to join the conversation.