Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Extended length of roughing toolpast with 3mm EM
Milling
1
Beiträge
1
Benutzer
0
Likes
3,143
Ansichten
Themenstarter
Hi,
I'm a relatively new user, and am practicing milling double-sided, with a work area of 240 x 200 mm. Each side has two toolpaths, one "rough" with a 3mm EM, the other a finishing cut with a 2mm EM. I'm generating the toolpaths with VCarve Pro, to "Mach 2/3 Arcs (mm) .txt", then running these sequentially on an 840/2. The 3mm EM is configured with 4.1mm pass-depth, 0.6mm stepover, 1800mm/sec federate, as per attached screenshot.
Here's the problem:
Vectric Pro times the roughing pass at circa 35 minutes, at a feedrate of 1500mm/sec, but the elapsed actual time for the 3 passes is nearer 6 hours! For the life of me I can't spot the error in the job-set-up. Any help in running this problem to earth would be most welcome.
Veröffentlicht : 28/08/2017 12:39 am
Forum Information
- 44 Foren
- 7,333 Themen
- 63.2 K Beiträge
- 2 Online
- 26.3 K Mitglieder
Unser neuestes Mitglied: MVorgrimler
Letzter Beitrag: Y axis not stopping during homing
Forum Icons:
Das Forum enthält keine ungelesenen Beiträge
Das Forum enthält ungelesene Beiträge
Themen-Icons:
Unbeantwortet
Beantwortet
Aktiv
Heiß
Oben angepinnt
Nicht genehmigt
Gelöst
Privat
Geschlossen