Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
4
Beiträge
3
Benutzer
0
Likes
4,611
Ansichten
Themenstarter
hello everybody,
I have a 420 Stepcraft.
Maybe can you help me.
At the third trial, when I launch the 0 reference, the axis Z comes to touch the frame of the axis X and the motor doesn't stop.
2 test more, same result.
last test , motor doesn't move, just hears vrrrr.
when I use the manual command, the motor start in the same direction but i use the opposite button>
limit Switch is tested and ok.
thanks
best regards
Guillaume
Veröffentlicht : 30/11/2015 11:47 pm
Ive noticed if numlock on the keyboad is turned on then the motors dont stop. Try turning off numlock on the keypad.
Veröffentlicht : 12/12/2015 2:22 am
Themenstarter
Thanks Jonalm for your answer.
But it doesn't work.
Best regards 🙁
Veröffentlicht : 21/02/2016 10:45 pm
make sure the switch is engaging when the Z axis moves to the left and presses the X axis switch.
Also make sure the motor is not stalling very close to the edge of the machine. Machine needs to be well tuned.
Veröffentlicht : 23/02/2016 12:00 pm
