Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
4
Beiträge
2
Benutzer
0
Likes
5,054
Ansichten
Themenstarter
Can someone kindly tell me what the setting for the z axis is when it exits and goes back into the toolpath please. I have a problem when the Woodburning pen hitting the maximum z+ stop. I want to adjust the amount the tool rises from the material before it enters the zero point to start the job. At the moment which is default seems to move about 50+mm up the z axis. So if I have a thick piece of material the tool tops out.
Veröffentlicht : 14/08/2016 9:49 pm
top of toolpaths setting in the right hand side - there is a Z home figure. this will sort you out.
Veröffentlicht : 15/08/2016 12:16 am
Themenstarter
top of toolpaths setting in the right hand side - there is a Z home figure. this will sort you out.
Rory, do you mean this one as I cannot see one on the toolpath page.
Veröffentlicht : 15/08/2016 3:11 am
This setting is not in the UCCNC - its in the CAM package
its the Z home / Z retract / Z start point.
in Vectric this is top right above toolpath operations
sorry for late reply.
Veröffentlicht : 30/08/2016 9:33 pm
