- Posts: 1
- Thank you received: 0
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
scutty wrote: I recently got a D3 with the MM100DI spindle and had a similar problem. I could run it manually without the cable attached but it would not work at all with UCCNC.
Turns out the cable was wired incorrectly from the factory. SC sent me a new cable that worked. If you open the D15 connector on the cable and send a pic I can see if it the same issue.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
We use cookies on our website. Some of them are essential for the operation of the site, while others help us to improve this site and the user experience (tracking cookies). You can decide for yourself whether you want to allow cookies or not. Please note that if you reject them, you may not be able to use all the functionalities of the site.