- Posts: 2
- Thank you received: 0
Question
Tool not droping of during Automatic Tool change
- MrJarl
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
20 Jun 2022 15:04 #62439
by MrJarl
This message has an attachment image.
Tool not droping of during Automatic Tool change was created by MrJarl
Our Automatic Tool change is working 90% of the time we use it but then every now and then the tool just doesn't come off.
So when it tries to change to the new tool the first tool is still on making it drive down the first to into the second tool wich breaks the first tool.
Does anyone know why this happens?
So when it tries to change to the new tool the first tool is still on making it drive down the first to into the second tool wich breaks the first tool.
Does anyone know why this happens?
This message has an attachment image.
Please log in or register to see it.
Please Log in or Create an account to join the conversation.
- [email protected]
-
- Offline
- Forum Nutzer
-
Less
More
- Posts: 3
- Thank you received: 0
08 May 2023 20:04 #63120
by [email protected]
Replied by [email protected] on topic Tool not droping of during Automatic Tool change
I had the same problem.
If you encounter burnmarks on the SK 15 tool holder, you are running to fast with the feedrate.
The SK15 holder is not as rigid as the collett on the spindle without a n ATC.
Therefore you must increase rpm to 20-22000 and set the feedrate to about 2000mm / m
Also you can have to little pressure on the air. You need at the minimum 8 bar pressure. This means you have to have a 810 bar compressor.
If you encounter burnmarks on the SK 15 tool holder, you are running to fast with the feedrate.
The SK15 holder is not as rigid as the collett on the spindle without a n ATC.
Therefore you must increase rpm to 20-22000 and set the feedrate to about 2000mm / m
Also you can have to little pressure on the air. You need at the minimum 8 bar pressure. This means you have to have a 810 bar compressor.
Please Log in or Create an account to join the conversation.