- Posts: 4
- Thank you received: 0
Question
D840 running problems
- Neston-High-School-Makerspace
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
06 Apr 2023 18:43 #63056
by Neston-High-School-Makerspace
D840 running problems was created by Neston-High-School-Makerspace
Hello,
Why do I need to reboot the CNC every time I try to set up a project?
I am unable to move in any Axis.
After using the touch sensor to measure the material thickness and pressing start from here, the D840 using UCCNC stopped working and will not run the program or reset.
Is there any good guide to running the stepcraft, as most YouTube jump too quickly over the complex parts?
We designed our work in Fusion 360 with XYZ in the upper middle part of the design.
Why do I need to reboot the CNC every time I try to set up a project?
I am unable to move in any Axis.
After using the touch sensor to measure the material thickness and pressing start from here, the D840 using UCCNC stopped working and will not run the program or reset.
Is there any good guide to running the stepcraft, as most YouTube jump too quickly over the complex parts?
We designed our work in Fusion 360 with XYZ in the upper middle part of the design.
Please Log in or Create an account to join the conversation.