Frage What parts do I need to use UCCNC software

In order to use the UCCNC software on your STEPCRAFT machine you need the following

• UC100 USB CNC controller
• UC100 license for your UC100 controller
• To download the software from the UCCNC website
• You need to remove the WinPC USB card and install a parallel adaptor card
• You then either need the setup files (please email us) or you need configure step by step using the pin settings in the STEPCRAFT manual

Hallo Rory,
Yesterday arrived my UCCNC-Package.
The installing Guide is very good. After a Short Time it was ready to work

This is good to hear.

Thank you.

a big Hello Rory from the nord of switzerland

im a cnc prof but new in stepcraft
at the moment i perform a room to be my Stepcraft-paradise

The sc 840 is here but she is waiting a few days more for her place to start working ...

there are some reasons to prefere the Uccnc because its closer to fanuc and other prof cnc software then ncpc.

My Questions:
-can you tell me where to get the configuration data for sc 2 840 ?
-are there any problems to think about with the use of sc 840 and uccnc?
-the "tool measure thing" ( ) is it working ?

beside: i enyoy stoneycnc- videos on youtube with a great pleasure

best reards
Bruno

bvs schrieb: there are some reasons to prefere the Uccnc because its closer to fanuc and other prof cnc software then ncpc.
Bruno

Agree - the interface is very clean.

• live view of the machine
• MDI input on screen
• Easy to follow and simple
• 45euro for a licence... we should all very thankful to CNC drive

bvs schrieb: -can you tell me where to get the configuration data for sc 2 840
Bruno

We have our machine setup and running. Please email us.

bvs schrieb: -are there any problems to think about with the use of sc 840 and uccnc?
Bruno

We have many STEPCRAFT V1 machines working with UCCNC without problems. The V2 configuration is the same setup with some settings a little different. For example the pitch of the ballscrews is different. So the motor settings for accurate movement in the software are slightly different.

bvs schrieb: -the "tool measure thing" ( ) is it working ?
Bruno

Yes the probing function on UCCNC does work. We just need to take some time to confgure it for the STEPCRAFT and make the documentation.

bvs schrieb: beside: i enyoy stoneycnc- videos on youtube with a great pleasure
Bruno

Thanks!

tx a lot Rory
most of all, i like g54... and mdi

if one does not know it, he does not miss it

but i miss it badly and im lucky i found it in uccnc

im testing mach3 now for the first time.
There is also g54... and mdi. What a surprise
So what is better, Mach3 or uccnc?

Hello Rory,

can I get the UC100, the parallel interface (I bought my stepcraft with a USB Board) and the software bundled and for how much with shipping to Germany?