- Posts: 16
- Thank you received: 0
Question
Imperial/Inch mode
- Radford
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
25 Jun 2017 17:44 #48293
by Radford
Imperial/Inch mode was created by Radford
Can my Stepcraft2 840 be run in Inch mode (G20) rather than Metric mode (G21)?
Please Log in or Create an account to join the conversation.
- Doug
-
- Offline
- Forum Nutzer
-
27 Jun 2017 05:55 - 27 Jun 2017 05:58 #48332
by Doug
Stepcraft 2/840, StoneyCNC industrial HF spindle, 4th axis, TurboCAD 2016 Professional 64 bit, MeshCAM, GWizard feeds & speeds calculator, UCCNC
Hobby use: guitar building (luthiery), dsgb.net
Replied by Doug on topic Imperial/Inch mode
Check the UCCNC user manual Section 4.1 to see if the G20 code is supported.
http://www.cncdrive.com/UCCNC/UCCNC_usersmanual.pdf
It jumps from G19 to G28 so it doesn't look like it. I noticed UCCNC telling me that G21 was unsupported recently so it might return an error message in any case.
Doug
http://www.cncdrive.com/UCCNC/UCCNC_usersmanual.pdf
It jumps from G19 to G28 so it doesn't look like it. I noticed UCCNC telling me that G21 was unsupported recently so it might return an error message in any case.
Doug
Stepcraft 2/840, StoneyCNC industrial HF spindle, 4th axis, TurboCAD 2016 Professional 64 bit, MeshCAM, GWizard feeds & speeds calculator, UCCNC
Hobby use: guitar building (luthiery), dsgb.net
Last edit: 27 Jun 2017 05:58 by Doug.
Please Log in or Create an account to join the conversation.