Hi Joel, Attached is a screen shot of my UCCNC spindle configuration page - mine is an HF350, but probably differences are trivial between the two ...

If it were me I would take up DerRoy's offer of his UCCNC + UC100 - at a good second hand discounted price 👿 This route has proven very strai...

FR4 pcb material is never totally flat, so measuring its Z profile is no guarantee that it will not flex when a tool is applied. Found that out the h...

Hi Khepri, I've used my V2/420 for pcb engraving/milling, and like you I have chosen the Eagle - pcb_gcode.ulp route. UCCNC/UC100 does all that ...

Hi Xinort, With the greatest respect to Thomas, I think that for someone new to the machine even 8 hours is unrealistically short. It took me the ...

Found it!!!! Right at the beginning of the profile file is the following:- "[Screensetsettings] mainscreenfilename=Defaultscreenset &l...

Hi, Am I right in saying that you are now fully functional?? Do hope so, these software niggles are a pain in the derriere!! Incidentally I have...

Hi, Don't really understand how the installation completes with an important file missing. I have attempted to send you a copy of mine, but it may...

Hi, Don't really understand how the installation completes with an important file missing. I have attempted to send you a copy of mine, but it may...

Not quite sure what you are after - do you means the c:UCCNCScreens folder? Obviously something critical is missing. If the s/w doesn't install co...

Sounds as though your V1.2 installation is corrupt - I would be tempted to uninstall and then re-install v1.2.. make sure it works correctly using the...

I had the same concern when I recently updated from V1.1027 to V1.2xxx, however Rory assured me that there would be no problem in using my V1.1 versio...

Hi Miguel, Glad the assembly is proceeding well - yet again Rory has exemplified true customer service. Keep up the good work. Peter

Hi, If you are thinking of a DIY unit, be very careful that the microswitch you choose is properly specified. The cheapo ones from China usually h...

I don't know if VCarve has this option, but Cut2D has an option on the setup page to scale a design to job size. Is it possible that this box is ti...