tool length sensor

Hi, have you looked at the file to see if the two settings have actually been changed, when I set my 2-600 up i followed the instructions and altered the M31 file in the system manually (did not download it) and mine works perfectly

I replaced the my original M31 file with the downloaded M31 file. They are not the same, mine have only a few lines while the downloaded M31 have more codes lines. If you ask me to modify it i could not do that cause i do not know what shall i i do. Can somebody email me this M31 pls?

Check this link:-

https://www.stepcraft-systems.com/en/forum/operation/4246-tool-sensor

I posted a copy of my working M31 macro in that forum - may be of some use to you (I added some comments to help my understanding of its operation).

Peter

Hi,

This is a link to Stepcraft USA Youtube pages, which shows step by step the set up for the sensor.
Also all the information is on their website on the FAQ page.

https://www.youtube.com/watch?v=41BrgUkvoCE

@Peterg 1000 : I will go through that forum posts because my problem is the same as this video

https://youtu.be/jRPhX6QkC-A

@AlanUk : I did all steps as listed in that short video.

BTW i downloaded this M31 file.