- Beiträge: 24
- Dank erhalten: 8
Frage
Dressing V cutters.
- badgersurfer
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
11 Aug 2016 01:29 #36546
von badgersurfer
Dressing V cutters. wurde erstellt von badgersurfer
Does anyone dress their own 2mm up cut end mills, 3mm up cut end mills, V bits. If so what do you use? I am mostly interested in dressing the V bits at the moment?
regards
regards
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- peterg1000
-
- Offline
- Forum Nutzer
-
Weniger
Mehr
- Beiträge: 380
- Dank erhalten: 131
11 Aug 2016 09:37 #36550
von peterg1000
SC 420/2, Industrial VFD spindle from StoneyCNC
UC100 + UCCNC
Cut2D, Autosketch10, Draftsight, Eagle 9.5.1
There is no problem, however simple, that cannot be made more complicated by thinking about it.
peterg1000 antwortete auf Dressing V cutters.
Hi,
Take a look at this link - it discouraged me from attempting to recover ruined tools, even "full sized" ones.
Peter
Take a look at this link - it discouraged me from attempting to recover ruined tools, even "full sized" ones.
Peter
SC 420/2, Industrial VFD spindle from StoneyCNC
UC100 + UCCNC
Cut2D, Autosketch10, Draftsight, Eagle 9.5.1
There is no problem, however simple, that cannot be made more complicated by thinking about it.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.