Hi-ya,
I’ve been back and forth with both Stepcraft and Rory about this.
The general consensus is that any 3.5mm jack plug will fit. I tried 2, 3 and 4 pole plugs, they all fit fine.
If you’re thinking of wiring up the tool length sensor the 2 pole (mono) plug is simple to wire up as it’s only got 2 terminals.
With the 3 and 4 pole plugs you’ll have to check UCCNC diagnostics to find the correct terminals.
Be aware, when you plug just the jack plug in, the ‘probe’ indicator will light up, when you find the two correct terminals it will go out.
I found wiring the jack plugs a bit fiddly for my hands, so I cut off a 3.5mm 3 pole plug from some crappy headphones and soldered the wires together (after testing which are the two correct wires of course), works great.
You can get the plugs from ebay for a couple of pounds.
Veröffentlicht : 04/11/2017 5:29 p.m.