- Beiträge: 53
- Dank erhalten: 68
Frage
Laser DL445 EN
- jeyb
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
21 Apr 2017 21:53 #46556
von jeyb
Laser DL445 EN wurde erstellt von jeyb
Hi did anyone test the new laser 2watt?
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- bmartens
-
- Offline
- Forum Nutzer
-
Weniger
Mehr
- Beiträge: 46
- Dank erhalten: 12
20 Okt 2017 02:51 #50910
von bmartens
bmartens antwortete auf Laser DL445 EN
Old thread, but yep. Check out the laser section of this forum.
It does some things quite well. My main challenge is learning the ideal parameters for different materials (focussing mainly on marking so far, rather than cutting), and then using more challenging programs such as fusion 360 with it.
(VCarve desktop works pretty well using it as a custom end-mill, and the laser post-processor)
It does some things quite well. My main challenge is learning the ideal parameters for different materials (focussing mainly on marking so far, rather than cutting), and then using more challenging programs such as fusion 360 with it.
(VCarve desktop works pretty well using it as a custom end-mill, and the laser post-processor)
Folgende Benutzer bedankten sich: jeyb
Bitte Anmelden oder Registrieren um der Konversation beizutreten.