- Beiträge: 1
- Dank erhalten: 0
Frage
stepper motors not working
- powerofrah
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
04 Mär 2018 08:50 #53086
von powerofrah
Dieser Beitrag enthält Bilddateien.
stepper motors not working wurde erstellt von powerofrah
I cannot get the stepper motors to move using manual in uccnc. I can hear the motors making a noise but they do not spin. I even completely removed the z axis motor from the machine and tried to manually spin it using uccnc but it still does not spin. It is as if the wiring is wrong but they match the diagram.
Dieser Beitrag enthält Bilddateien.
Bitte anmelden (oder registrieren) um sie zu sehen.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- peterg1000
-
- Offline
- Forum Nutzer
-
Weniger
Mehr
- Beiträge: 380
- Dank erhalten: 131
05 Mär 2018 09:52 #53114
von peterg1000
SC 420/2, Industrial VFD spindle from StoneyCNC
UC100 + UCCNC
Cut2D, Autosketch10, Draftsight, Eagle 9.5.1
There is no problem, however simple, that cannot be made more complicated by thinking about it.
peterg1000 antwortete auf stepper motors not working
Hi,
Check you power supply voltage - it should be 30VDC, give or take a volt or so. It should not change when jogging steppers either.
Peter
Check you power supply voltage - it should be 30VDC, give or take a volt or so. It should not change when jogging steppers either.
Peter
SC 420/2, Industrial VFD spindle from StoneyCNC
UC100 + UCCNC
Cut2D, Autosketch10, Draftsight, Eagle 9.5.1
There is no problem, however simple, that cannot be made more complicated by thinking about it.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.