Benachrichtigungen
Alles löschen
Operation
3
Beiträge
3
Benutzer
0
Reactions
3,719
Ansichten
Themenstarter
Got Stepcraft M100 construction kit.
After starting WinPC-Nc Starter software and trying to make "inizialing the machine" action got ERROR "Homing switch active"
While manual moving on XYZ directions is ok.
What's wrong?
Veröffentlicht : 22/02/2021 8:50 p.m.
check your connections of the Stepper motors to the mainboard and/or the endswitches.
This error shows when a connection is bad or broken.
In winpc go to the Special functions menu and select signal test, now you can possibly see where it goes wrong.
good luck
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Veröffentlicht : 24/02/2021 9:42 p.m.
I had the same problem and it turned out that I had connected the two wires on my Y-axis home button not correct (should be the two outer connectors only
Veröffentlicht : 14/08/2021 2:45 p.m.
