Benachrichtigungen
Alles löschen
Operation
1
Beiträge
1
Benutzer
0
Reactions
634
Ansichten
Themenstarter
Recently I had to cut 10mm holes and when my CNC cut them, holes were 9.5mm.
I use Fusion360 and I've tried drill operation, 2D adaptive clearing, stock to leave=0, all of it. Same result.
I even tried to set feed rate ridiculously slow but the the hole is always the same...
When I cut bigger holes, it's accurate. Only small holes.
Any suggestions?
Tnx
Veröffentlicht : 02/02/2025 4:39 p.m.
