Active Member
Beigetreten: Sep 1, 2017
Last seen: Sep 1, 2017
Themen: 1 / Antworten: 4
Antwort
Sn or Al Laser cutting.

Aluminium is shinny and i am sure you need a co2 laser to cut that . Unless you can obtain a diode laser with a suitable nm rating. My experience is...

Vor 7 Jahren
Antwort
Repetier Host / Slic3r issue HELP

In slic3r you can set your print bed size and where the origin is located. I had some fun doing this for a cheap 3d printer, i had to keep altering t...

Vor 7 Jahren
Forum
Antwort
Any suggested laser-engravable materials for new D:-445 (445 nm blue laser)

Anything reflective or transparent will not burn, so be careful of the laser bouncing off reflective light colours and of course going straight thro...

Vor 7 Jahren
Topic
Replies: 0
Views: 3135
Antwort
Material for milling - suggestions please

Hi, it is impossible to inform you of which material to use for milling 0.25 to 25mm. It all depends on what job you are undertaking. That will sugg...

Vor 7 Jahren
Forum