bluskies
bluskies
@bluskies
Active Member
Beigetreten: Aug 30, 2015
Last seen: Dez 8, 2016
Themen: 1 / Antworten: 7
Antwort
Stepcraft Drag Knife

Hi! Yes, you adjust the knife depth on the dragknife to go through the vinyl and halfway into the backing paper, maybe 0.1 mm or just test. Then th...

Vor 8 Jahren
Forum
Antwort
New Laser module for the Stepcraft

Hi! I ordered one a few days ago. The web shop says shipping from early December. Those videos and other preview said there would be two models (2 ...

Vor 8 Jahren
Forum
Antwort
Best CAD/CAM solution for Stepcraft?

Thanks 🙂 Which machine interface do you use it with? Is it good at auto creating optimized tool paths or does it require a lot of manual "fiddlin...

Vor 9 Jahren
Forum
Topic
Forum
Replies: 4
Views: 6304
Antwort
Track roller tightening

I had the golden rings in there from the start. I haven't tightened it much, just enough that I could see that the rollers stopped moving. If I loosen...

Vor 9 Jahren
Antwort
Track roller tightening

Oh, thank you for your reply. I have inserted the rings, but am still having the same problem :blink:

Vor 9 Jahren
Antwort
Track roller tightening

I have the same problem, and only a german manual, so not sure I'm following it properly. How did you fix it?

Vor 9 Jahren
Antwort
english 840 build manual

Same here. The only manual in the box was in german, and I can not find an english manual for download on the Stepcarft websites :S I know a few word...

Vor 9 Jahren