Hello Rob and welcome to the forum. I hope your Stepcraft performs as good as it looks and you don't run into too many difficulties. You might want...

what happened at the end it just stopped? It stopped when the cycle finished, as normal. The video is not complete; there is a pocket cut missing bec...

Here is a 13 minute video of a successful cut of the aluminium switch plate for my Brian May Red Special replica guitar. Note that the screw hole dril...

I think those kind of statements you find in the specs refer to a professional CNC mill. Reading your parameter proposal seconds this .. 0.1 mm depth ...

To clear this up with facts and figures, 6061 T6 aluminium machinability is listed as "acceptable" with 95 HB Brinell hardness: So yes, not "th...

Wrong type of Aluminium. The specs I found say that it is bad to mill/drill. Firstly, this is completely incorrect. 6061 (T6) should machine no probl...

Hello guys, Incredible! I gave my stepcraft a last chance and disassemble/rebuilt it another time, and... it works Incredible! I gave my Stepcraft...

I just started reading the CNC Cookbook aluminum article. Does anyone have g-wizard settings for a 600 with a Kress? Thanks! David, Forget G-Wizar...

Hi. Users on this forum are helpful if you describe your problem accurately and, where applicable, illustrate with clear photographs. :cheer: ...

Rahul, You never replied to me regarding your enquiry about the 4th axis rotary table that I listed for sale in December. Did you ever get your Pay...

Kamaka had a geat CNC set-up which was 5 axis working on the principle of a lathe to present the work at the various angles to the tools. Best of l...

Hi Pete. I'm glad you're on your way and that the fix was simple. In a way that can be a huge relief but also truly maddening. I chose to apply a s...

I had the same issue but it didn't cause the Y axis to lose steps, thankfully. I wasn't very impressed but it eventually stopped being an issue. I wou...