Can someone tell me if the XYZ datum set on the Cut 2D is the same as the zero point on UCCNC software??? Check this pdf: It shows everything t...

What end mills did you use?

Thanks for the help @jvalencia. Now it is working fine 🙂 I install the Win-PC and move all axis with no problem. great!

You are not following the procedure. Unscrew the Y axis screws, let the machine move till it touchs the switch, tighten the screws. That's all. ...

I've seen that Stepcraft is now selling a branded UCCNC package with profiles included for all stepcraft models. It's available here: It would ...

Good work. I did the same (but in the back side):

Glued? with glue???

Here: UCCNC and here: Software Be careful and read the notes when changing between major releases ("profiles..."). I have not updated to the la...

Try contacting the developer at:

I think your Y axis rollers are too tight and cause too much friction.

Just tried the new version. I can't understand that screen editor at all.

Well, the problem here is that it's a tablet. Don't expect lots of resources/speed from it. 2GB ram is very few for Win8 alone. I think your dev...

Are you using the latest version?