file Frage cant get the A Axis to feed

  • majorcrankie
  • majorcrankies Avatar Autor
  • Offline
  • Forum Nutzer
  • Forum Nutzer
Mehr
10 Jun 2017 00:42 #48023 von majorcrankie
cant get the A Axis to feed wurde erstellt von majorcrankie
hello all I cant seem to get the a axis to feed . I have did what stepcraft has said and still no luck anybody have any ideas . I think its a setting in uccnc but not sure what to look for

thanks for all and any help

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
15 Jun 2017 22:55 #48137 von Doug
Doug antwortete auf cant get the A Axis to feed
Check on the Configuration/Axis Setup tab for the A axis whether the axis is enabled or not (checkbox ticked).

Doug

Stepcraft 2/840, StoneyCNC industrial HF spindle, 4th axis, TurboCAD 2016 Professional 64 bit, MeshCAM, GWizard feeds & speeds calculator, UCCNC
Hobby use: guitar building (luthiery), www.facebook.com/DougShortGuitarBlog/

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Powered by Kunena Forum

© 2020 STEPCRAFT GmbH & Co. KG