15 Aug 2023 08:16 #63295
von kristoffertrix
Hello
I have an issue controlling my Stepcraft 4th axis in UCCNC. The A-axis keeps spinning even though it should only rotate 360 degrees making the A axis in UCCNC count below -1400.
When I adjust the Steps pr. unit to 30 it seems to solve the problem (then a full rotation axis a = 360 units i UCCNC). That said I am a bit unsure if that is the right way to solve the problem?
Do you know if the the problem is in UCCNC or it a hardware problem? I have attached a picture of the print card.
I look forward to hear from you.
Br. Kristoffer
Dieser Beitrag enthält Bilddateien.
Bitte anmelden (oder registrieren) um sie zu sehen.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.