Benachrichtigungen
Alles löschen
Operation
4
Beiträge
3
Benutzer
0
Reactions
5,319
Ansichten
Themenstarter
hello everybody,
I have a 420 Stepcraft.
Maybe can you help me.
At the third trial, when I launch the 0 reference, the axis Z comes to touch the frame of the axis X and the motor doesn't stop.
2 test more, same result.
last test , motor doesn't move, just hears vrrrr.
when I use the manual command, the motor start in the same direction but i use the opposite button>
limit Switch is tested and ok.
thanks
best regards
Guillaume
Veröffentlicht : 30/11/2015 11:47 p.m.
Ive noticed if numlock on the keyboad is turned on then the motors dont stop. Try turning off numlock on the keypad.
Veröffentlicht : 12/12/2015 2:22 a.m.
Themenstarter
Thanks Jonalm for your answer.
But it doesn't work.
Best regards 🙁
Veröffentlicht : 21/02/2016 10:45 p.m.
make sure the switch is engaging when the Z axis moves to the left and presses the X axis switch.
Also make sure the motor is not stalling very close to the edge of the machine. Machine needs to be well tuned.
Veröffentlicht : 23/02/2016 12:00 p.m.
