- Beiträge: 61
- Dank erhalten: 50
Frage
Couple of stepcraft issues
- jonalm
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
12 Dez 2015 00:29 #28083
von jonalm
Couple of stepcraft issues wurde erstellt von jonalm
My ball screw on z Axis may be slightly bent i noticed the ballrace that fits on the tool holder was moving slightly within it, ballrace looks fine. see video.
2nd tested the base and its slightly out after bad engraving test.
2nd tested the base and its slightly out after bad engraving test.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- tikka
-
- Offline
- Forum Nutzer
-
Weniger
Mehr
- Beiträge: 105
- Dank erhalten: 27
13 Dez 2015 09:09 #28119
von tikka
Stepcraft 600SF (version 1) parallel port
Proxxon IBS/E
Mach3
devCad Cam Pro; devWing Cam; devFus Cam; Profili Pro 2
tikka antwortete auf Couple of stepcraft issues
I would take the ball screw out, rotate it on a smooth surface to see if it is bent and replace if needed.
Stepcraft 600SF (version 1) parallel port
Proxxon IBS/E
Mach3
devCad Cam Pro; devWing Cam; devFus Cam; Profili Pro 2
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- jonalm
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
- Beiträge: 61
- Dank erhalten: 50
14 Dez 2015 10:55 #28175
von jonalm
jonalm antwortete auf Couple of stepcraft issues
I think its definitely bent as the bearing in the tool holder wobbles about when moving the z axis.
Just wondering the best way to take out and replace the screw without removing all the gantry and wiring.
Just wondering the best way to take out and replace the screw without removing all the gantry and wiring.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.