Benachrichtigungen
Alles löschen
Show us your Stepcraft Creations
7
Beiträge
5
Benutzer
0
Reactions
9,033
Ansichten
Themenstarter
Almost confined the engraving to the bin when i lost connection to uccnc when i turned on an air compressor that was connected to the same power extension as the stepcraft when i was engraving. Had to reboot and mangaged to get near to the original zero position.
Veröffentlicht : 24/03/2016 11:13 p.m.
Great work . Well done
Stepcraft 2 430
Kress 800 FME
UCCNC + UC100
Cut2D Desktop
Veröffentlicht : 13/05/2016 11:26 p.m.
Hello,
Would you share, how did you engrave acrylic? What bit and setting did you use?
Thank you for your time and answer.
Veröffentlicht : 04/05/2017 1:47 a.m.
Themenstarter
I used a v cutter for engraving with a pass depth of 0.3mm, stepover 20%, spindle speed 17000rpm, feedrate 25mm/sec.
I used a 2mm single flute to cut out the profile SEE VIDEO AS I USED SAME SETTINGS HERE.
https://www.youtube.com/watch?v=IwpIfmuRA5Q
Veröffentlicht : 07/05/2017 8:53 p.m.
thank you for sharing.
Veröffentlicht : 09/05/2017 6:31 a.m.
