Press Enter after typing the profile name in and before pressing the create profile button. It works! Thanks Karoly. Nice workaround for small soft...

Very nice!

Thanks hoedur, Main controller will be Raspberry Pi 2 with installed RetroPie Project so it's mean almost any kind of emulator and thousands of gam...

Thanks Worldhusky, Thats good idea with doors! For now I am going to use small neodymium magnets to hold the console when is not in use. If you lo...

You can load any gcode and X and Y positions remain the same (Z as well). Do not zero it! You need new X and Y positions only if you remove miling par...

Hi, Select vectors only for 1.5mm endmill, create toolpath, save gcode. After that select vectors for 2.0mm, create toolpath and save code. Go ahea...

"Wheel" attached to housing. Now the laser point is much smaller: Measure difference in x/y between tool and laser pointer. It should...

Hi, I am using small laser pointer mounted on the bottom side of extrusion adaptor. It helps me a lot when I do something and need to remove machin...