Excellent piece of detective work Peter !! I look forward to the first episode of CSI : Stepcraft !! Thanks for all of your effeorts on behalf of ...

Apologies for slow response gentlemen. Too busy chipping! Ummm, my electronics goes back to the Neolithic period so a little out of my depth here....

Good news is that new board installed and I am up and running again! Bad news is that I have replaced the assumed culprit voltage regulator on the ...

Thanks Peter, Little bit clumsy when it comes to soldering so plan is :- New board is ordered and should be with me tomorrow (Tuesday). I will ...

Thanks for the input guys, CNCmiller - As Andreas points out, no power so can't be the switch. But I tried it anyway, just for completeness ! Unf...

Have just checked and fuse appears to be fine. Thanks for the suggestion.

Following on from my previous post, here are a few more jewellery boxes made for friends, one in Lacewood and another in quarter sawn oak. ...

Thanks for the prompt reply Karoly. I have checked both the configuration of all inputs and active high/low settings a number of times. And the mo...

Had a similar problem with point 2) when assembling my 420. I found that it was due to a number of "pinch" points along the length of the aluminium e...