Yes it does. The .NC file has all the code needed to cut your toolpath as you defined it.

Thank you for the explanation. So I should set the feedrate in Aspire instead (the G-code generator I'm using) and leave the velocity at 1700? T...

As per above - its adobe / flash issue with latest update on windows causing some dekstop programmes to fail to launch. One of which is the UCCNC. ...

I wouldn't buy the tool length sensor. You won't use it a lot in my opinion, it's 40 euros to skip a 20 second manual measurement. Not worth it.

To be honest, if it's already used, price should start at 50%. That sucks yeah. I encourage you not to sell it. You'll regret it the day it left y...

Now add a wooden cover and turn it into a classical toy.

Amazing work. An estimation of the money you've spent here?

Very nice!!! What software did you use to create gcodes from picture??? I used inkscape -> qcad -> v-carve

The hardest part was the paint: I hate painting because I mostly fail big time at it for some reason. This is not perfect either, but I can live with...

What did you use for a program to setup the G Code for the Donek? Vectric stuff? And what did you use for values (offset, etc)? We have one here an...

you need a CAM software to translate your vector graphics into machine code.

Well, they sell these PLA filaments, but I don't know what other filaments are supported by the 3D head. And depending on your injector diamet...

Evan check this too: If you want full precission, go with Exact Mode.

It sounds like your Y axis is jogging. Did you adjust every axis as the manual indicates? I would remove the floor and run the program again so you...