0.01! Nice.... yes always test manually by pressing the button before offering it up to the tool 🙂

can you post Gcode?

99.99% its your Y axis loosing steps due to mechanical tuning needed.

Awesome - interesting to see how accurate it is.

Mechanical tuning required. power down and check all axes move freely roller adjustment pulley adjustment move the axes by hand and feel w...

Agree with Peter. slow and steady wins the race.

hmm.. interesting. not sure will see can i find out.

1) bolt sacrificial layer to the table in all areas so it can't move in the middle 2) skim the top of the sacrificial layer with the machine 3) ...

Connect to port 1 of the ETH module? you have to select the box, type in the value and hit enter key. Then apply + save not sure why you can...

1) out of square? the way to solve is not by post processor... by hardware. adjust the two gantry sides? this would be very tricky with the post ...

Welcome back 🙂

Quality engraving!

you need to select "save all toolpaths to file" and then they all have to be the same tool. if you have separate tools you need to save separate to...

This setting is not in the UCCNC - its in the CAM package its the Z home / Z retract / Z start point. in Vectric this is top right above toolpa...

Z axis stalling on retract possibly - check Z axis. Mechanical tuning