I'll tried it and it does help some of the way. Of course the terms are different so I am not sure what goes where. More reading to go.

I hope you guys don't mind me asking in English, I have a 420 and want to use Grbl. does anyone have their settings I could use? I have it all working...

I would use this calculator but I don't know what numbers to put in. Does anyone know?

I'm having this issue as well in X. I have tried losing everything and doing it back up but it still jams at random places. I've played with them so m...

I think you could be right. I have gone through and tightened everything as there were a few things loose. see if that helps.

The spindle is too long. Not your fault. I had the same issue!! yuppie cost of sending it back 🙁

I now have it up and running. Well I did, but I found out that my x-axis spindle was too long so I had to send it back to stepcraft. UPS says it is on...

Where is the manual to wire up Arduino to stepcraft for Estlcam. I got a letter yesterday saying the cnc machine arrives tomorrow. I was expecting it ...

thank you. looks like i'm off to get a Arduino UNO then.