Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
ThomasDbg wrote: Wir sind gespannt auf Deine ersten Ergebnisse, was hast du mit der Fräse vor?
Please Log in or Create an account to join the conversation.
Norbert wrote: Willkommen!
Wenn'd bei der Einrichtung von LinuxCNC hilfe brauchst:
linuxcnc-emc2-installation-einrichtung
Please Log in or Create an account to join the conversation.
Effad wrote: Du hast da nämlich 4mm/Umdrehung Spindelsteigung, während das Stepcraft-Dokument nur 2mm/Umdrehung ausweist.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.