- Posts: 468
- Thank you received: 268
sikousikou wrote: ... ich fräse manchmal DIN A4 Platinen und das braucht 2 bis 3 Stunden ...
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
ThomasDbg wrote: Oha! Ich hätt´da mal ´ne Platine.....
Was schaltet die? ´n Atomkraftwerk?
Eine kleine Bitte habe ich noch, es wäre schön wenn Du uns Deinen richtigen Namen verrätst, so ist es doch gefälliger, Dich anzusprechen. Noch schöner wäre es natürlich, wenn Du Dich uns unter "User stelen sich vor" kurz vorstellst. Danke!
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
MagIO2 wrote: Thanks for sharing!
Jetzt fehlt nur noch die Okulus Rift, damit der "Bediener" auch das sieht, was der Robi sieht und ein paar Beine für den Guten und ich brauche nicht mehr selbst zur Arbeit fahren.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Raimond wrote: Hallo sikousikou,
da meine Proxxon nach ca 4 Wochen auch das zeitliche segnet , muss eine andere endgültige Lösung her.
Ich habe einfach keine Lust das Ding alle 4 Wochen zur Reparatur zu schicken und eine Zwangspause einzulegen.
Da es von Stepcraft zeitnah wohl keine Spindel geben wird, bin ich am überlegen mir auch eine Kress zu holen.
Es mit einen Dremel(170W) zu versuchen, wie mir von Herrn Urban vorgeschlagen wurde, möchte ich eigentlich vermeiden. Der Dremel ist auch nicht gerade günstig und ob das Teil was taugt, weiss ich auch nicht. Ich möchte einfach nicht vom Regen in die Traufe.
Da Du ja eine Kress verwendest, würde mich mal interessieren, wie die Stepcraft das nun verkraftet. Oder Sollte ich mich noch nach einer anderen Alternative umsehen? Nur welche...???
Gruß
Raimond
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.