I bought some large chains and aluminium profiles because I need more space for my grounded cables. The original chains were just large enough for on...

Check out my aluminium vacuum hose holder, I'm quite happy with it!

I didn't go much further since I've a busy job atm. But: the machine received some major updates as the side panels and back panel made of hard alu...

Well, the G-500 has a work area which is X-500.0 mm Y-360.0 mm, so not that large, but large enough for me. The enclosure is almost ready, I'll h...

Rory is really helpful, I second that!

I don't expect any of you to follow my steps: the Stepcraft is just fine, and I've enjoyed mine. This is for me a little step further, and what I l...

Btw: this machine can reach much higher speeds easily. The seller just want the customers to stay safe and use lower speed settings. I can tell it...

I had a lot of fun with the StepCraft, but I was kind of disappointed about the Nema 17 motors (especially for the 600 and 840 models!). So yeah, I...

Thank you for the explanation. So I should set the feedrate in Aspire instead (the G-code generator I'm using) and leave the velocity at 1700?

My idea too. As for the t-slot table (400 x 600 according to the seller): it can be found here: link I'm really thinking of selling my SC 420/2 ...

Nice material! 😉

I received the spare-parts a few days ago, and I've rebuild the machine. Everything has been tuned, and it's now working great!

Correction: RVS is a Dutch term for stainless steel (screws)... my bad! 😆