Just checked on my UC100 - green light only when laptop powered up. Blue light appears during UCCNC load and flickers occasionally during that proces...

As promised - an almost complete kit of parts for the super mousetrap!! Peter

Agreed - a tool length sensor is an absolute must have, no guesswork and spot on every time. I did find that once I used double speed probing the sec...

Hi SFDeeJay, Did you check that Mach3 didn't overwrite the UCCNC drivers for UC100?? Just a thought. Peter

I think the one you mention is primarily an accurately machined corner piece with known dimensions. When electrical contact is made, it seems as thoug...

Hi SFDeeJay, No need to be embarrased about asking for help - we have all been in your position during the learning process. Only too glad to pass ...

Hi SFDeeJay, Surely what you are after is a simple tool length sensor similar to this one? Standard Stepcraft accessory if you don't want to make o...

Hi, Glad to hear that SFDeeJay persisted and finally had success. IMHO anyone starting to assemble an SC machine would be well advised to do a ...

Hi, Gerry's modification seems to do the trick on the original M31.txt. However since I don't have a tool changer, I have modified the file to do ...

Hi Gerry, Thanks for that - you are definitely VERY much cleverer than I !!!!!!!!!!! I'll try that later this morning. Peter. Just review...

Hi SiSt, Thanks for that information and the link to the cncdrive forum. Looks like it's an interesting problem to solve for someone a lot cleverer...

Hi Doug, Thanks for posting the photos and video - very impressive!! Appreciate the machining parameters too - most useful, did you get those value...

Hi Garth, Thanks for sending your defunct control board in my direction for disposal. 👿 I thought to put my electrical/electronics so call...

Hi Doug, Wow - that's what I call a real success!!! Thanks for some really useful machining parameters too - I'll make a careful note of those whe...