- Posts: 6
- Thank you received: 0
Question
4th Axis with winpcnc usb. Anybody has it working?
- Steve
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
27 Nov 2016 20:17 #39833
by Steve
4th Axis with winpcnc usb. Anybody has it working? was created by Steve
I have been trying to use the 4th axis with winpcnc usb but have been not successful.
Any hint on how to make it work?
Thanks
Any hint on how to make it work?
Thanks
Please Log in or Create an account to join the conversation.
- CNCMiller
-
- Offline
- Forum Nutzer
-
Less
More
- Posts: 224
- Thank you received: 81
28 Nov 2016 10:50 #39857
by CNCMiller
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Replied by CNCMiller on topic 4th Axis with winpcnc usb. Anybody has it working?
Hello Steve,
it is very hard to tell what is possibly wrong if you not tell us more about your setup.
you have installed the 4th axis control unit on the mainboard?
and use the upgraded Winpc-nc usb, not the starter version?
what is your system setup, what program you use for your preprocessor?
it is very hard to tell what is possibly wrong if you not tell us more about your setup.
you have installed the 4th axis control unit on the mainboard?
and use the upgraded Winpc-nc usb, not the starter version?
what is your system setup, what program you use for your preprocessor?
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Please Log in or Create an account to join the conversation.