- Posts: 24
- Thank you received: 2
Question
Whats this for??
- Richard777
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
31 Jul 2016 12:48 #36233
by Richard777
Stepcraft 840
Kress Spindle
UCCNC
Vectric Aspire
This message has an attachment image.
Whats this for?? was created by Richard777
Hi All,
I have just completed my build of an 840. I have a 'left over cable and plug. Please see the attached. Can anyone tell me what this is for. Am I being 'thick' and missed a build step?
I cant find this in the build guide
Please let me know
Cheers
Rich
I have just completed my build of an 840. I have a 'left over cable and plug. Please see the attached. Can anyone tell me what this is for. Am I being 'thick' and missed a build step?
I cant find this in the build guide
Please let me know
Cheers
Rich
Stepcraft 840
Kress Spindle
UCCNC
Vectric Aspire
This message has an attachment image.
Please log in or register to see it.
Please Log in or Create an account to join the conversation.
- DocBrown
-
- Offline
- Forum Nutzer
-
31 Jul 2016 14:36 #36238
by DocBrown
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
DK5LH/G11
This message has an attachment image.
Replied by DocBrown on topic Whats this for??
It's a grounding cable. It is needed because sometime due to the rotating spindle static electricity will disturb the machine control board. You will find a installation manaul in the Service / Support / Manuals section of the Stepcraft webpage. The manual is different in the German and English section. Hava a look at the English manual in this screenshot:
Here it is a USB cable but mine is also a 230V plug.
Here it is a USB cable but mine is also a 230V plug.
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
DK5LH/G11
This message has an attachment image.
Please log in or register to see it.
Please Log in or Create an account to join the conversation.