- Posts: 23
- Thank you received: 48
Question
Engraving on Melamine Board
- athersmith
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
05 Jul 2015 19:22 #23055
by athersmith
Stepcraft 2 600
HFS 350
UCCNC
This message has an attachment image.
Engraving on Melamine Board was created by athersmith
Hi All
After putting up some new shelves in my workshop I had some odd bits of melamine left over so I thought about engraving them with my new Stepcraft 600/2.
First attempt attached.
I used whiteboard pens to enhance the etching and add a touch of colour.
After putting up some new shelves in my workshop I had some odd bits of melamine left over so I thought about engraving them with my new Stepcraft 600/2.
First attempt attached.
I used whiteboard pens to enhance the etching and add a touch of colour.
Stepcraft 2 600
HFS 350
UCCNC
This message has an attachment image.
Please log in or register to see it.
The following user(s) said Thank You: MagIO2, Rory
Please Log in or Create an account to join the conversation.