Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Kreativkeller-Lahde wrote: Wenn Ich in meinem CAD Programm (QCAD) einen Buchstaben einfüge, und den dann als .dxf abspeicher
und dann in WinPC-NC aufrufe, kommt immer die Meldung "Fehler - Daten nicht darstellbar"
Ich habe versucht es dann in Estlcam aufzurufen, da sagt es "Leere oder inkompatible Zeichnung"
Wo dran liegt das ?
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Ja, gibt es - schau Dir mal den Dialog Menü / Automatische Funktionen / Objekte automatisch erzeugen an.Schorsch30 wrote: H
1.) Muss ich wirklich jeden Buchstaben einzeln definieren? Gibt es keine Möglichkeit, alle Buchstaben zu selektieren und mit einer Definition auszustatten?
Schorsch30 wrote: 2.) Wenn ich die Buchstaben "innen" carven möchte und durch einen "nervösen Finger" versehentlich "außen" gewählt habe - wie kann ich das rückgängig machen?
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
We use cookies on our website. Some of them are essential for the operation of the site, while others help us to improve this site and the user experience (tracking cookies). You can decide for yourself whether you want to allow cookies or not. Please note that if you reject them, you may not be able to use all the functionalities of the site.