- Posts: 33
- Thank you received: 14
Please Log in or Create an account to join the conversation.
Vielleicht schon zu vorsichtig.OpaHoppenstedt wrote: Auf youtube kann man sehen wie mit 3 Meter/min(!) durch die Bretter gepflügt wird. Ich fange mal ganz vorsichtig an mit 180mm/m (3mm/s).
OpaHoppenstedt wrote: Fragen:
1. woher kommt das richtungsabhängige Kreissägengeräusch? Sterben die Kugellager in der Proxxon?
2. ist 2mm Frästiefe bei 3mm/s schon zuviel? Ich hatte nicht den Eindruck das die Stepcraft überfordert ist.
3. kann man die "Haare" an den Schnittkanten irgendwie reduzieren oder vermeiden?
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
ThomasDbg wrote: Hey, Volker,
was ist ein Lötfant?
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
OpaHoppenstedt wrote: Danke, sehr interessant. Das Foto zeigt anscheinend das neue Modell. Wie es aussieht sind beide Kugellager am unteren Wellenende verbaut. Da frage ich mich wie denn seitliche Kräfte, z.B. von einem langen Fräser, aufgenommen werden sollen. Die Kugellager sind dann der Drehpunkt. Wenn das obere Wellenende nur über das Ritzel vom Motorlager gestützt wird dann wundert mich gar nichts mehr.
Genau so siehts aus.
Gruß Guido
Please Log in or Create an account to join the conversation.
We use cookies on our website. Some of them are essential for the operation of the site, while others help us to improve this site and the user experience (tracking cookies). You can decide for yourself whether you want to allow cookies or not. Please note that if you reject them, you may not be able to use all the functionalities of the site.