Question Hello everybody

hi guys,
i'm new on this forum, i write from italy;
waiting for my ST2 420+uc100+uccnc with tool lenght sensor,t-slot table, vise pm60, HF 500 spindle and vacuum adapter;

after i must assemble it and start
after i've preventivated to take all the spare parts like enclosure, 4th axes and automatic tool changer;

if you have any council to give me, are well accepted

thank you all!!!
bye!!

Ciao Andrea.

Welcome to the forum. Hopefully you won't have any problems with your 420 machine; the smaller footprint models don't seem to exhibit the issues "a small percentage of users" have experienced with their machines.

Doug

Hello Andrea,

Welcome,I hope you will enjoy your machine.
A tip on forehand RTFM (Read The F* Manual) no joke make yourself familiar with the parts to use.
Don't tighten the screws on the portal, align x-axis first and Y-axis bed, first slide in your T-slot plate, test the smooth rolling of the Y-axis, then tighten the screws.

good luck