- Posts: 152
- Thank you received: 97
Question
Help with acrilic
- jvalencia
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
30 Oct 2016 19:45 - 30 Oct 2016 19:46 #38800
by jvalencia
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
This message has attachments images.
Help with acrilic was created by jvalencia
The finished piece is opaque, how can I make it transparent? I used a 6mm 2-flute end mill.
If you see the small pockets, they were done with a 2mm 1-flute end mill and they are more transparent.
If you see the small pockets, they were done with a 2mm 1-flute end mill and they are more transparent.
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
This message has attachments images.
Please log in or register to see it.
Last edit: 30 Oct 2016 19:46 by jvalencia.
Please Log in or Create an account to join the conversation.
- ubo
-
- Offline
- Forum Nutzer
-
30 Oct 2016 20:06 #38803
by ubo
Gruß,
Uwe
WinPC-Nc V4, EstlCAM V11 / V12
www.ubo-cnc.de
Replied by ubo on topic Help with acrilic
Try to polish or heat (flame or hot air)
Gruß,
Uwe
WinPC-Nc V4, EstlCAM V11 / V12
www.ubo-cnc.de
Please Log in or Create an account to join the conversation.
- jvalencia
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
- Posts: 152
- Thank you received: 97
31 Oct 2016 18:02 #38827
by jvalencia
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
Replied by jvalencia on topic Help with acrilic
Tried with a flame but still not transparent.
I might look at acrilic end mills.
I might look at acrilic end mills.
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
Please Log in or Create an account to join the conversation.