1. Forum
  3. English Forum
  5. Machine
  7. Operation
  9. Control of Spindle using UCCNC

file Question Control of Spindle using UCCNC

  • coanda
  • coanda's Avatar Topic Author
  • Offline
  • Forum Nutzer
  • Forum Nutzer
More
21 Mar 2015 23:45 #17559 by coanda
Control of Spindle using UCCNC was created by coanda
Hi, I see that there are serial ports on the back of my 420 and the 350w motor controller. Am I able to connect the two and have control of the spindle via UCCNC?

I haven't tried this yet in case bad things happen!

Thanks,

coanda

Please Log in or Create an account to join the conversation.

More
22 Mar 2015 23:58 #17615 by Rory
Replied by Rory on topic Control of Spindle using UCCNC
yes - you will be able to control the spindle. There is a relatively slow optocoupler on the STEPCRAFT control card. Therefore the PWM frequency output at max RPM is important. the new version of the UCCNC that we are testing allows you to change the PWM frequency at the max RPM. So we will soon have it configured.
The following user(s) said Thank You: coanda, Firefly, peterg1000

Please Log in or Create an account to join the conversation.

  • coanda
  • coanda's Avatar Topic Author
  • Offline
  • Forum Nutzer
  • Forum Nutzer
More
23 Mar 2015 00:39 #17616 by coanda
Replied by coanda on topic Control of Spindle using UCCNC
That's good news. Thanks for the info.

Please Log in or Create an account to join the conversation.

  1. Forum
  3. English Forum
  5. Machine
  7. Operation
  9. Control of Spindle using UCCNC
Powered by Kunena Forum

© 2024 STEPCRAFT GmbH & Co. KG

We use cookies

We use cookies on our website. Some of them are essential for the operation of the site, while others help us to improve this site and the user experience (tracking cookies). You can decide for yourself whether you want to allow cookies or not. Please note that if you reject them, you may not be able to use all the functionalities of the site.

Ok Decline
More information | Imprint