Question Z-Axis triggers limit switch at start of run

Start
Prev
1
Next
End

esfoleo
Topic Author
Offline
Forum Nutzer

27 May 2015 13:48 #21488 by esfoleo

Z-Axis triggers limit switch at start of run was created by esfoleo

Hello All,
New to SC and just assembled a SC2-600 with UCCNC and UC100. Everything works fine and I loaded a SC600 profile supplied by the retailer here in Aus.
Problem is that whenever I load G-Code and start the cycle the Z axis immediately triggers the hard limit switch stopping the entire process.

I'm new to desktop CNC so not sure how to fix the issue.

Any suggestions and tips welcome.

Thanks
Frans

Please Log in or Create an account to join the conversation.

MagIO2
Offline
Forum Nutzer
Zu viele Ideen und zu wenig Zeit

27 May 2015 14:37 #21494 by MagIO2

Replied by MagIO2 on topic Z-Axis triggers limit switch at start of run

Triggering the switch looks like it is moving in the wrong direction. It shall go down but it goes up.

Should be possible to change that in your software settings.

SC 420 mit DIY parallel + ~~Proxxon mit Mod~~ + HF500 + SprintLayout + LibreCAD/QCAD + FreeCAD +~~WinPC starter/USB~~->EstlCAM + EstlCAM LPTAdapter + EstlCAM Handrad + DIY Vakuumtisch

Gruß, Andreas

Please Log in or Create an account to join the conversation.

Rory
Offline
Forum Nutzer

27 May 2015 19:28 #21515 by Rory

Replied by Rory on topic Z-Axis triggers limit switch at start of run

Does it retract up into the limit switch?

you can change this in the CAM? Safe Z?

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

choose your language

Question Z-Axis triggers limit switch at start of run